Installation and Commissioning of Disc Mixer

The disc mixer is largely composed of the following components.

1. The main body of the mixer, including machine body, a stirring chamber, and a stirring rotor structure;
2. One set of cycloidal pinwheel reducer. After the customer has placed an order, the foundation is built based on the process flow chart of our factory-designed or self-designed, and the corner hole is reserved on the basis (reasonable design, small vibration, and a very strong concrete foundation is not necessary).

Commissioning of the disc mixer:

The machine has been debugged and passed the strict quality and technical inspection approval before leaving the factory. However, problems causing by on-site maintenance or operation still need to be adjusted.

1. The machine should be started without load. It is forbidden to start the machine with materials to avoid damage;
2. The large stones and iron blocks in the materials must be strictly prohibited;
3. Check whether all the bolts are loose before starting up the machine;
4. Check whether the oil level in the bearing housing and the reducer is in place;
5. Start the main motor, check whether the direction of rotation is reversed, if so,immediately stop debugging;
6. It is strictly prohibited to stop the machine with materials.